Customer Reviews for VEVOR 27 PCS Pull and Press Sleeve Kit, 45# Steel Removal Installation Bushes Bearings Tool Kit, Bush Removal Insertion Sleeve Tool Set Works on Most Cars and LCV, HGV Engines

Needed to remove bushings from my 2003 Dodge Ram, this tool worked great, I did not use an impact on it, just 1/2 ratchet, easily popped out the bushing, pressing in the new bushing was even easier. Better pricing the Amazon, good product.

Boy a usarlas por primera vez y espero den un buen resultado por que la calidad es genial entonces confío en hacer un muy buen trabajo con estos equipos

This tool worked great I ordered a sub frame for my car and it came with the wrong bushings I got the push and pull tool and took old out and put the new ones in no sweat .....highly recommend....thanks guys

Replaced engine mounts on 1990 VW Cabriolet , was easy. Had to use shop press to put new engine mounts in. Highly recommended.

Very good set. Did everything I needed them to do. Case stays shut and holds everything secured. Has plenty of different sizes and work good in my home shop.

I use this for refrigerator to pump the water from the gallon fast

I could've saved a lot of money if i would have just bought this first! You can use an impact. Just be careful, Don't torque down! Run it tight, then use a 5LB hammer to slap the arm of the bushing and it will pop. Well worth the money!

Purchased May 2023 for $76. Good value for the price. Kit weighs 28 lbs. I will use the sleeves with my press. I do not plan on using the threaded rod, so I don't care about their quality (another reviewer gave 1 star because threaded rod broke). Sleeves are 55mm in length, and the OD agrees with the specifications. Specifications claim that the "wall thickness" is 5mm, but they are actually closer to 4.5mm. This makes the ID typically closer to 9mm smaller than the OD (For example the largest sleeve is actually 82x73mm instead of the claimed 82x72mm)

It was easy to set up. I just forget to get the air out of the tube. It took awhile to finally start working.its only for my ice maker. The noise was very quick s few seconds. Otherwise the system is doing it's job. The instructions says 5 gallons but you can use it with 3 gallon jug. It slides to the size jug you have.

Great pump for the money. Works well. It's downfall is the noise. It has a very loud thumping noise.