43 Reviews
- Most Recent
- Most Helpful
carpe diem
With or without Gear Lever : Yes ; Baffle diameter : 218 mm ;
satisfaction
Goods received good delivery fast logistics to force good quality satisfaction
0
M3
With or without Gear Lever : None ; Baffle diameter : 185 mm ;
works good but we did not receive the stop lever
works good but we did not receive the stop lever
0
Jen Park
With or without Gear Lever : Yes ; Baffle diameter : 218 mm ;
Worked well
Aside from intial issues it worked out well
0
MG
With or without Gear Lever : Yes ; Baffle diameter : 218 mm ;
Very functional for a fair price
Very easy to assemble. Fairly easy to operate and setup. Watching a couple of YouTube videos will help with the settings. Is working as advertised. I like the time savings it provides. In my opinion fairly priced for the benefits. I use it in combination with my Epson TM-C3500 printer.
0
Leo Yes
With or without Gear Lever : Yes ; Baffle diameter : 218 mm ;
Do the work
Work as expectedThe only problem was received with EU cable and not US.But you can replace it with a PC cable.
0
Zachary Scott
With or without Gear Lever : Yes ; Baffle diameter : 218 mm ;
Decent product and I would buy it again. Used for US postage printing for about six rolls a week without fail for several weeks.
This rewinder does what it is supposed to do and is worth purchasing for the roughly quarter of the cost of other machines. It does have English comments over what I assume is Chinese instructions, so you can make out what the three buttons do. It rotates slower than the YouTube videos but does keep up once you pause the printer for the initial rewind start. It has a bar at the bottom that goes on top of what you rewind so it will throttle itself. Perfect fit for the Zebra 1" rolls we rewind (ZM400 printer.) We ended up using a little duct tape to hold the plastic spacer for the 1" rolls, but not a big thing. I would put loctite on the screws when you assemble it. The meta guide near the controls needs to be placed away from the yellow sensor about a quarter inch to allow it to spin freely. So far we have rewound about twenty rolls without issue (about six rolls a week.)Bottom line is it does the job, it is a decent product, and I'd buy it again. I would like to open up the product and add grease to the gears to quiet them down a bit. I would also like to know how to speed it up since it has the throttle bar at the bottom to handle the initial few revolutions.
0
J. D.
With or without Gear Lever : Yes ; Baffle diameter : 218 mm ;
Pretty solid winder
Easy to use and figure out
0
REBECCA WOOD
With or without Gear Lever : Yes ; Baffle diameter : 218 mm ;
Five Stars
Works like a charm
0
Melissa D
With or without Gear Lever : Yes ; Baffle diameter : 218 mm ;
Five Stars
Great product for the price. Its a little clunky and very basic, but it does the job well.
0
RM
With or without Gear Lever : None ; Baffle diameter : 185 mm ;
Easy to use.
Easy to use. Works great with our small thermal printer
0