VEVOR US EN
Select the country/region, language, and currency you prefer for shopping.
Delivery to
Your Address
Hello, Sign In
Account & Order
Free Delivery 30-day No-hassle Returns 12-month Warranty
VEVOR Ultrasonic Cleaner 6L Ultrasonic Vinyl Cleaner 7-12 Inch 8 Records Ultrasonic Vinyl Cleaning Machine 180W Ultrasonic Records Cleaner with Drying Rack for Home Store

Customer Reviews for VEVOR Ultrasonic Cleaner 6L Ultrasonic Vinyl Cleaner 7-12 Inch 8 Records Ultrasonic Vinyl Cleaning Machine 180W Ultrasonic Records Cleaner with Drying Rack for Home Store

Customer Reviews

Ratings by Features

  • 4.8
  • 4.7
  • 4.7
  • 4.7
  • See More See Less
84 Review(s)
Clear filters
Another Dave in Boston Another Dave in Boston
Very effective cleaning but motor that rotates LPs died on Day 5
This generic ultrasonic cleaner can clean tools, glasses, jewelry, etc., but with its purpose-built bracket, spindle and motor it is designed for deep cleaning LP vinyl records. It's very effective at that. I ran it at 30º C [approx. 86º F] for 30 minutes per 8-record batch. The amount of \"crud\" that came off of my records and out of their grooves to collect in the bottom of the tank was disgustingly impressive. For cleaning fluid I was using distilled water (the tank hold approx. 6 liters or a bit over a gallon) + a capful of Kodak Photo-Flo as surfactant. Unfortunately, the motor that rotates the LPs through the ultrasonic cleaning fluid stopped rotating after 4-5 days of use and fewer than 10 batches of records. (The spindle holds 8 records per batch.) I was not pushing the machine hard, allowing it plenty of time to cool down between cleaning batches. Note: The motor and the ultrasonic cleaner each plug in separately; you'll need two outlets to plug both things in. And the heater does not stop when the ultrasonic cleaner's timer expires so you must turn the heat off yourself. Yes, it's noisy at an irritating frequency but it's not deafening. I put it in a distant room and shut the door. I also added a couple of fender washers to the bolt for the motor mount to make it more secure and easy to raise and lower.
Oktyabr Oktyabr
Easiest way to clean vinyl LPs, with some caveats
This unit DOES work and does work well, but there are some things to be aware of: TL;DR: It’s a bit fiddly to get working properly and it IS noisy, but it does a great job of cleaning vinyl records, even with straight distilled water. Don’t run it too hot, or too full, and make sure everything is properly assembled before use. Run a full cleaning cycle, just for the tank, when you first get it. Always wipe down the inside of the tank with clean microfiber after use. At length: 1) While the tank should be clean when you first receive it, give it 30 minutes with just distilled water at at least 30 C before you start washing records. Mine actually left an oily film on top of the water! Nothing I want to be submerging my precious collection in! Dump the water and then start again from fresh, giving the tank a quick wipe down with a new, or at least very clean microfiber cloth. Wipe it down between uses too! While most of the gunk will go out the tap with the water, some stays behind and will dry on the bottom of the tank if you don’t wipe it up first. 2) Use a separate thermometer! I actually use two, a meat probe and an infrared. Both have confirmed that the water, in my experience anyway, gets three or four degrees warmer than what is indicated on the display. I'm not sure where records start to warp (some say 60 C or even sooner) but it seems the general consensus is that 30 C is about as high as you want to go, 40 C max, for any extended amount of time. 3) There IS a flat surface on the spindle for the screw to tighten against and it does work. Get your best phillips screw driver out for this though, get it as tight as possible, and check it every batch. I thought I had it tight but after my first two batches of albums, the spindle just pulled off. I suspect that the ultrasonics vibrate the screw and make it back out, if it isn't REALLY tight. You also must make sure that the spindle fully contacts the face of the motor, through the lift groove, befo
Kent A. Winrich Kent A. Winrich
Does a really good job!
I was not really sold on how this would work when I bought it, but now that I have used it, I am very impressed. The records come out looking almost new, the surface noise is much lower. Its noisy but not as bad as I thought it was going to be. I am now working on every album I have :-) I add about 15-20 drops of Tergikleen to the distilled water. You will not be disappointed!
Rick Rick
Effective
There are many different opinions on the internet about the best cleaning solution and the best cleaning procedures. Cleaning with Tergikleen then using this machine to rinse the tergikleen off is pretty darn effective for me.
AlexSolo AlexSolo
You can eaasily fix the plexiglass disks to fit the shaft.
Haven’t tried it out. Still assembling. The disks didn’t initially fit the shaft, just slighty too tight. I used a metric hex key size 6 to ream out the hole just enough that the disks slid on tightly. Don’t over use. I will report back on how well it works.
Peter Taylor Peter Taylor
Fantastic deep clean
Works exceptionally well. I previously swore by a manual vinyl cleaning process, the Disc Doctor fluid and brushes system for two decades. The Disc Doctor approach is like a component upgrade, such a tremendous improvement in audio quality, so long as you spend the time to get the rinse correct... and repeat when you get it wrong. The Happybuy is infinitely more convenient, way faster for a bunch of records, and the audio results are way more consistent than the manual method. Audio result is at least as good as the Disc Doctor method. Unit is noisy, at a penetrating frequency, and you will want ear protection if you are going to sit nearby while it operates. I followed third-party recommendations and purchased an inexpensive adjustable voltage adaptor to reduce rpm. The device is very much a hobbyist assembly of components and inexpensive. I am left wondering what will fail first. But so far so good! Very happy.
TLMJ TLMJ
Good for the price.
Does an acceptable job of cleaning and not as noisy as two previous ultrasonic cleaners.
Dennis J. Metzger Dennis J. Metzger
Easy to use, easy to clean and does a great job cleaning precious vinyl albums.
This review is based on my initial use, about 400 albums cleaned thus far. The system is easy to assemble, only a screwdriver needed. While some have complained of the operational noise, I've not experienced that issue. The motor driving the albums rotation is low/ dull sound which is not a problem even when standing next to the system. The actual ultra-sonic cleaning action is a 'soft bubbling' sound. Of course this observation is based on my particular ears and feedback from my wife. The actual work result, album cleaning, is very dramatic. In addition to clearing surface / visible material, the deep track cleaning is amazing. To say the audible difference is noticeable is such an understatement. I've been changing the distilled water after 100 albums. The systems design makes this a simple task, direct the drain hose into a container and open the valve.
Paul Warren Paul Warren
Great Value!
This is Vevor brand machine, which has a very good reputation for cleaning metal parts and jewelry. I was not too familiar with its vinyl record cleaning abilities until I saw a YouTube video with a record enthusiast touting the features and deep-cleaning mastery. The video set my expectations high, and after using the ultrasonic cleaning machine for a few hours, I can truly say I am very pleased. Compared to dedicated record cleaning machines costing several hundred or a few thousand dollars, this machine is a veritable value because I am convinced it can perform the cleaning on the same level as the more expensive machines. What the $1,000+ machines give you over this one is drying capability and a higher level of machine noise. The noise level on the Vevor, to my ears, is comparable to an air-fryer machine...significant but tolerable if you are a distance of 10 or more feet away from the machine. The vinyl record accessories, motorized (rotational) mounting rack, clear spacing discs, and record drying rack, are all excellent. I additionally purchased the Tergikleen product and a photo wetting agent to add to the distilled water for thorough cleaning, and I am impressed with the results. One minor complaint is the instructional literature in the package is not thorough, so some intuitive knowledge and perhaps viewing a video might be needed to get everything set up. So, for less than $250 I have deep-groove record sanitizing machine that is on par with wet-and-vacuum machines costing $600 (Record Doctor X) and other ultrasonic cleaning and drying machines costing well over $1,000. Recommended.
Chevyt1963 Chevyt1963
I like it but…
The only issue I have is the motor turns too fast in my opinion to allow deep cleaning to occur. If the motor turned a little slower the ultrasonic action would have an opportunity to deeply clean the grooves. As it is, I am running longer clean sessions to give deep cleaning to occur.

People Who Bought This Item Also Bought

TOUGH TOOLS, HALF PRICE